Single high frequency medical series uninterruptible power supply

The importance of voltage regulators and UPS power supply for medical equipment

1. Pure sine wave output, battery start

2. LCD screen displays load size, battery capacity, mains mode/battery mode/bypass mode and fault indication

3. With output short circuit protection and overload protection

4. With lightning surge protection

5. Full time lightning protection, noise and surge protection

6. CPU design, self detection function and high reliability

7. It can be matched with power monitoring software "electronic management expert" to realize remote monitoring

8. Intelligent battery management system extends battery life

9. The network interface port adds automatic and safe system shutdown

10. SNMP accessory slot for power network management as required

11. Automatically adjust too high or too low voltage

12. Network level line adjustment to prevent signal burrs

13. AC filter is added to effectively eliminate ultrasonic artifacts and avoid wave shaped radiation interference on two-dimensional echo images

The importance of voltage regulators and UPS power supply for medical equipment

1.Brand: Kingwall

2.Specification and model: C1K/C2K/C3K/C6K/C10K

3. Capacity: 1KVA/2KVA/3KVA/6KVA/10KVA

4. Input wiring: 3KVA and below are equipped with plug power lines, and 6KVA and above need to be equipped with power line terminal wiring

5. Input voltage: 176V~276V

6. Input frequency: 46 ～ 54Hz

7. Output voltage: 220V ± 1%

8. Input frequency: 50 (1 ± 0.2%) Hz (battery mode)

9. Current peak ratio: 3:1

10. Display description: LCD screen displays load size, battery capacity, mains mode/battery mode/bypass mode and fault indication

11. Output waveform: sine wave

12. Charging time: 4 hours to 90%, 9 hours for 6KVA or above

13. Standby time: 10~15 minutes for full load, double for half load

14. Conversion time: 0 seconds

15. Overload capacity: 110%~130% 30min to bypass, and more than 130% 1min

16. Communication interface: RS-232, optional SNMP

1. Ambient temperature: 0 ℃~40 ℃

2. Humidity: 0~90%

3. Altitude: not more than 2000m

4. Installation site: no gas, steam, dust, dirt and other explosive and corrosive media with serious insulation

5. Installation site: no serious vibration or turbulence

6. Other instructions: Any special use conditions that do not meet the above provisions shall be determined by the user unit and our factory through consultation